RSS M-380 Owner's Manual page 47

3.
Filter
fig.ScrChFilt.eps
c
a
b
a. FILT button
This turns the filter on/off.
b. FREQ knob
This adjusts the filter frequency in the range of 20 Hz–20.0 kHz.
c. OL (Overload) indicator
This will light red when the output of the filter exceeds the
OVER Lev setting specified in the METER SETUP popup (p. 96).
By default, HPF (High Pass Filter) is assigned to the filter, and
the FREQ knob will adjust the cutoff frequency.
Detailed filter settings are made in the EQUALIZER popup. For
details, refer to "Four-band EQ operations" (p. 84).
4.
Gate/expander
fig.ScrChGate.eps
a
c
d
a. GATE button
This turns the gate/expander on/off.
b. THRE (Threshold) knob
This adjusts the threshold level of the gate/expander in the
range of -80.0 dB–0.0 dB.
c. IN meter
This shows the input level of the gate/expander. For stereo-
linked channels, two meters (L and R) will be shown.
d. GR meter
This shows the amount of gain reduction for the gate/expander.
e. OL (Overload) indicator
This will light red when the output of the gate/expander
exceeds the OVER Lev setting specified in the METER SETUP
popup (p. 96).
Up to twenty-four gate/expander units can be turned on.
For detailed gate/expander settings, refer to "Gate/expander
operations" (p. 73).
e
b
Input channel operations
5.
Compressor
fig.ScrChComp.eps
a
c
d
a. COMP button
This turns the compressor on/off.
b. THRE (Threshold) knob
This adjusts the threshold level of the compressor in the range
of -40.0 dB–0.0 dB.
c. IN meter
This shows the input level of the compressor. For stereo-linked
channels, two meters (L and R) will be shown.
d. GR meter
This shows the amount of gain reduction for the compressor.
e. OL (Overload) indicator
This will light red when the output of the compressor exceeds
the OVER Lev setting specified in the METER SETUP popup (p.
96).
Up to twenty-four compressors can be turned on.
For detailed compressor settings, refer to "Compressor
operations" (p. 78).
6.
Insert indication
fig.ScrChIns.eps
a. EXT FX
If an external effects processor is inserted, this shows the
number of the inserted EXT FX.
By moving the cursor to EXT FX and pressing [ENTER], you can
access the EXT FX 1–4 tab or EXT FX 5–8 tab of the EFFECTS
screen.
Inserting an external effects processor into a channel is done in
the EFFECTS screen. For details, refer to "Inserting an external
effects device" (p. 111).
b. FX INS
If FX1–FX4 are inserted, the number of the inserted FX is shown
here.
If the number is shown in white, the effect insertion is enabled.
If it is shown in gray, effect insertion is bypassed.
The FX INS number may have an appended "L" or "R." This
has the following significance.
e
b
a
b
47