RSS M-380 Owner's Manual page 153

[F1 (LAYER 1/2)] Accesses the LAYER 1/2 tab.
[F2 (LAYER 3/4)] Accesses the LAYER 3/4 tab.
[F3 (LAYER 5/6)] Accesses the LAYER 5/6 tab.
[F4 (BUTTON 1-8)] Accesses the BUTTON 1–8 tab.
[F5 (BUTTON 9–16)] Accesses the BUTTON 9–16 tab.
[F6 (OTHER)] Accesses the OTHER tab.
[F7 (CANCEL)] Cancels the changes and closes the
popup.
[F8 (OK)] Confirms the changes and closes the
popup.
5.
Move the cursor to the desired user fader assignment, and
press [ENTER].
fig.ScrUserFdrAsgn.eps
B A
The USER FADER ASSIGN popup will appear.
A.Applicable user fader
This indicates the user fader to which the USER FADER
ASSIGN setting applies.
B.Current assignment
This indicates the channel that is currently assigned to the
user fader.
C.Assignment channel select buttons
Here you can select the channel that will be assigned to the
user fader. The selected channel will be assigned to the user
fader.
In the USER FADER ASSIGN popup, the function buttons
perform the following operations.
[F1 (CH 1–24)]
[F2 (CH 25–48)]
[F3 (AUX/MAIN/
MATRIX)]
[F4 (DCA)]
[F8 (CLOSE)]
6.
Use [F1 (CH 1–24)], [F2 (CH 25–48)], [F3 (AUX/MATRIX)], or
[F4 (DCA)] to access the tab that contains the desired
channel.
C
Displays CH1–CH24 as the assign-
ment channel select buttons.
Displays CH25–CH48 as the as-
signment channel select buttons.
Displays AUX1–AUX16,
MATRIX1–MATRIX8, MAIN C as
the assignment channel select but-
tons.
Displays DCA1–DCA8 as the as-
signment channel select buttons.
Confirms the changes and closes
the popup.
7.
Move the cursor to the desired channel, and press [ENTER]
to select it.
8.
Press [F8 (CLOSE)] to finalize the changes and close the
USER FADER ASSIGN popup.
9.
Press [F8 (OK)] to finalize the changes and close the USER
PREFERENCE popup.
If you press [F7 (CANCEL)], the changes will be cancelled and
the USER PREFERENCE popup will close.
As an alternative to pressing [ENTER] in step 5, you can use the
value dial to edit the user fader assignment.
Switching to the user layer
1.
Press the USER layer button in the LAYER section (p. 23).
The USER layer button flashes, and the USER layer mode is
activated.
2.
Press the layer button that corresponds to the user layer
you want to switch to.
The selected layer button flashes.
The layer buttons correspond to the user layers as shown below.
AUX13-16/MTX layer button
AUX1-12 layer button
CH37-48 layer button
CH25-36 layer button
CH13-24 layer button
CH1-12 layer button
3.
Press the USER layer button.
The USER layer mode is switched off.
User settings
User layer 6
User layer 5
User layer 4
User layer 3
User layer 2
User layer 1
153