Show System Output Details - Enterasys D-Series Cli Reference Manual

Mode
Switch command, read‐only.
Example
This example shows how to display system information:
D2(su)->show system
System contact:
System location:
System name:
PWR1-A Status
----------
Ok
PWR2-A Status
----------
Not Installed and/or Not Operating Not Installed and/or Not Operating
Fan1-Status
-----------
Not Installed and/or Not Operating Not Installed and/or Not Operating
Uptime d,h:m:s
--------------
2,20:23:11
The following table provides an explanation of the command output.
Table 2-4 show system Output Details
Output
System contact
System location
System name
PWR1-A Status
PWR1-B Status
PWR2-A Status
PWR2-B Status
Fanx-Status
Uptime d,h:m:s
Logout
PWR1-B Status
----------
Not Installed and/or Not Operating
PWR2-B Status
----------
Fan2-Status
-----------
Logout
-------
30 min
What It Displays...
Contact person for the system. Default of a blank string can be changed with the
set system contact command
Where the system is located. Default of a blank string can be changed with the
set system location command
Name identifying the system. Default of a blank string can be changed with the
set system name command
Operational status for the power supply connected to PWR1-A on the switch.
Operational status for the power supply connected to PWR1-B on the switch.
Operational status for the power supply connected to PWR2-A on the switch.
Operational status for the power supply connected to PWR1-B on the switch.
Operational status of the fan(s). (This output not in use for the D2.)
System uptime.
Time an idle console or Telnet CLI session will remain connected before timing
out. Default of 5 minutes can be changed with the set logout command
logout" on page 2-27).
("set system contact" on page 2-24).
("set system location" on page 2-24).
("set system name" on page 2-23).
Enterasys D-Series CLI Reference 2-13
show system
("set