Commands
For information about...
show snmp persistmode
set snmp persistmode
save config
dir
show file
show config
configure
copy
delete
show tftp settings
set tftp timeout
clear tftp timeout
set tftp retry
clear tftp retry
show snmp persistmode
Use this command to display the configuration persistence mode setting.
Syntax
show snmp persistmode
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Usage
By default, the mode is set to "auto save," which automatically saves configuration changes at
specific intervals. If the mode is set to "manual," configuration commands are never automatically
saved. In order to make configuration changes persistent when the mode is manual, the save
config command must be issued as described in "Configuration Persistence Mode" on page 2‐34.
show snmp persistmode
Refer to page...
2-35
2-36
2-36
2-37
2-38
2-38
2-39
2-40
2-41
2-41
2-42
2-42
2-43
2-43
Enterasys D-Series CLI Reference 2-35