Resetting The Switch; Purpose; Commands; Reset - Enterasys D-Series Cli Reference Manual

Mode
Switch command, read‐only.
Usage
By default, switch timeout occurs after 15 minutes of user inactivity, automatically closing your
CLI session. Use the set logout command (page 2‐27) to change this default.
Example
This example shows how to exit a CLI session:
D2(su)->exit

Resetting the Switch

Purpose

To reset one or more switches, and to clear the user‐defined configuration parameters.

Commands

For information about...

reset

clear config
reset
Use this command to reset the switch without losing any user‐defined configuration settings.
Syntax
reset
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to reset the system:
D2(su)->reset
This command will reset all modules and may disconnect your telnet session.
Resetting the Switch
Refer to page...
2-45
2-46
Enterasys D-Series CLI Reference 2-45