Show Ciscodp Port Info; Show Ciscodp Output Details - Enterasys D-Series Cli Reference Manual

show ciscodp port info

Device ID : 001188554A60
Last Change : WED NOV 08 13:19:56 2006
Table 5‐2 provides an explanation of the command output.
Table 5-2 show ciscodp Output Details
Output Field
CiscoDP
Timer
Holdtime
Device ID
Last Change
show ciscodp port info
Use this command to display summary information about the Cisco discovery protocol on one or
more ports.
Syntax
show ciscodp port info [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, Cisco DP information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display Cisco DP information for Gigabit Ethernet port 1 in slot 1.
D2(su)->show ciscodp port info ge.1.1
port
----------------------------------------------
ge.1.1
Table 5‐3 provides an explanation of the command output.
5-8 Discovery Protocol Configuration
What It Displays...
Whether Cisco DP is globally enabled or disabled. Auto indicates that Cisco DP will
be globally enabled only if Cisco DP PDUs are received.
Default setting of auto-enabled can be reset with the set ciscodp status command.
The number of seconds between Cisco discovery protocol PDU transmissions. The
default of 60 seconds can be reset with the set ciscodp timer command.
Number of seconds neighboring devices will hold PDU transmissions from the
sending device. Default value of 180 can be changed with the set ciscodp holdtime
command.
The MAC address of the switch.
The time that the last Cisco DP neighbor was discovered.
(Optional) Displays Cisco DP information for a specific port. For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 6‐1.
state vvid
enable none
trusted cos
yes 0