Clear Port Mirroring - Enterasys D-Series Cli Reference Manual

Usage
Note that LAG ports and their underlying physical ports, as described in "Link Aggregation
Control Protocol (LACP)" on page 6‐36, cannot be mirrored.
Example
This example shows how to create and enable port mirroring with fe.1.4 as the source port, and
fe.1.11 as the target port:
D2(su)->set port mirroring create
D2(su)->set port mirroring enable

clear port mirroring

Use this command to clear a port mirroring relationship.
Syntax
clear port mirroring source destination
Parameters
source
destination
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to clear port mirroring between source port fe.1.4 and target port fe.1.11:
D2(su)->clear port mirroring
fe
.1.4
fe
.1.4
Specifies the source port of the mirroring configuration to be cleared. For
a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 6‐1.
Specifies the target port of the mirroring configuration to be cleared.
fe fe
.1.4 .1.11
fe
.1.11
fe
.1.11
Enterasys D-Series CLI Reference 6-35
clear port mirroring