Table of Contents
Advertisement
show system hardware
Example
This example shows how to display system information:
B3(su)->show system
System contact:
System location:
System name:
Primary PS Status
-----------------
Ok
Fan1-Status
-----------
Ok
Fan3-Status
-----------
Ok
Thermal Sensor 1
----------------
+28 degrees Celsius (82 degrees Fahrenheit)
Thermal Sensor 2
----------------
+31 degrees Celsius (87 degrees Fahrenheit)
Uptime d,h:m:s
--------------
0,0:26:52
Table
3‐2 provides an explanation of the command output.
Table 3-2 show system Output Details
Output
System contact
System location
System name
Primary PS Status
Fan Status
Thermal Sensor
Uptime d,h:m:s
Logout
show system hardware
Use this command to display the system's hardware configuration.
Syntax
show system hardware
3-12 Basic Configuration
Secondary PS Status
-------------------
Not Installed
Fan2-Status
-----------
Ok
Logout
-------
3 min
What It Displays...
Contact person for the system. Default of a blank string can be changed with the
set system contact command
Where the system is located. Default of a blank string can be changed with the
set system location command
Name identifying the system. Default of a blank string can be changed with the
set system name command
Operational status for the primary power supply.
Operational status of the fan trays.
Temperature reading from thermal sensor(s).
System uptime.
Time an idle console or Telnet CLI session will remain connected before timing
out. Default of 5 minutes can be changed with the set logout command
logout" on page 3-25).
("set system
contact" on page 3-23).
("set system
location" on page 3-22).
("set system
name" on page 3-22).
("set
Advertisement
Table of Contents
