Clear Port Advertise - Enterasys D-Series Cli Reference Manual

clear port advertise

Mode
Switch command, read‐write.
Example
This example shows how to configure port 1 to advertise 1000BASE‐T full duplex:
D2(su)->set port advertise ge.1.1 1000tfd
clear port advertise
Use this command to configure a port to not advertise a specific speed/duplex capability when
auto‐negotiating with another port.
Syntax
clear port advertise {port-string}{10t | 10tfd | 100tx | 100txfd | 1000t | 1000tfd
| pause}
Parameters
port‐string
10t
10tfd
100tx
100txfd
1000t
1000tfd
pause
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to configure port 1 to not advertise 10 MB capability for auto‐
negotiation:
D2(su)->clear port advertise ge.1.1 10t 10tfd
6-18 Port Configuration
Clear advertisements for specific port(s). For a detailed description of
possible port‐string values, refer to "Port String Syntax Used in the
CLI" on page 6‐1.
Do not advertise 10BASE‐T half duplex mode.
Do not advertise 10BASE‐T full duplex mode.
Do not advertise 100BASE‐TX half duplex mode.
Do not advertise 100BASE‐TX full duplex mode.
Do not advertise 1000BASE‐T half duplex mode.
Do not advertise 1000BASE‐T full duplex mode.
Do not advertise PAUSE for full‐duplex links.