Disconnect - Enterasys D-Series Cli Reference Manual

D2(su)->show users
Session
-------- ----- --------------------------
* telnet
telnet

disconnect

Use this command to close an active console port or Telnet session from the switch CLI.
Syntax
disconnect {ip-addr | console}
Parameters
ip‐addr
console
Defaults
None.
Mode
Switch command, read‐write.
Examples
This example shows how to close a Telnet session to host 134.141.192.119:
D2(su)->disconnect 134.141.192.119
This example shows how to close the current console session:
D2(su)->disconnect console
User Location
rw 134.141.192.119
rw 134.141.192.18
Specifies the IP address of the Telnet session to be disconnected. This
address is displayed in the output shown in "show users" on page 12‐15.
Closes an active console port.
Enterasys D-Series CLI Reference 14-15
disconnect