Configuring Cdp; Purpose; Commands - Enterasys D-Series Cli Reference Manual

This chapter describes how to configure discovery protocols.
For information about...

Configuring CDP

Configuring Cisco Discovery Protocol
Configuring Link Layer Discovery Protocol and LLDP-MED
Configuring CDP

Purpose

To review and configure the Enterasys CDP discovery protocol. This protocol is used to discover
network topology. When enabled, this protocol allows Enterasys devices to send periodic PDUs
about themselves to neighboring devices.

Commands

The commands used to review and configure the CDP discovery protocol are listed below.
For information about...
show cdp
set cdp state
set cdp auth
set cdp interval
set cdp hold-time
clear cdp
show neighbors
Discovery Protocol Configuration
5
Refer to page...
5-1
5-7
5-13
Refer to page...
5-2
5-3
5-4
5-4
5-5
5-5
5-6
Enterasys D-Series CLI Reference 5-1