Setting Speed And Duplex Mode; Purpose; Commands; Show Port Speed - Enterasys D-Series Cli Reference Manual

Setting Speed and Duplex Mode

Setting Speed and Duplex Mode

Purpose

To review and set the operational speed in Mbps and the default duplex mode: Half, for half
duplex, or Full, for full duplex for one or more ports.

Commands

For information about...

show port speed

set port speed
show port duplex
set port duplex
show port speed
Use this command to display the default speed setting on one or more ports.
Syntax
show port speed [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, default speed settings for all ports will display.
Mode
Switch command, read‐only.
Example
This example shows how to display the default speed setting for 1‐Gigabit Ethernet port 14 in
slot 3:
D2(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
6-10 Port Configuration
Note: These settings only take effect on ports that have auto-negotiation disabled.
(Optional) Displays default speed setting(s) for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 6‐1.
Refer to page...
6-10
6-11
6-11
6-15