Set Radius Accounting - Enterasys D-Series Cli Reference Manual

set radius accounting

Parameters
server
counter ip‐address
retries
timeout
Mode
Switch command, read‐only.
Defaults
If no parameters are specified, all RADIUS accounting configuration information will be
displayed.
Example
This example shows how to display RADIUS accounting configuration information. In this case,
RADIUS accounting is not currently enabled and global default settings have not been changed.
One server has been configured.
For details on enabling and configuring RADIUS accounting, refer to "set radius accounting" on
page 17‐8:
D2(ro)->show radius accounting
RADIUS accounting status:
RADIUS Acct Server
------------------
1
set radius accounting
Use this command to configure RADIUS accounting.
Syntax
set radius accounting {[enable | disable] [retries retries] [timeout timeout]
[server ip_address port [server-secret]
Parameters
enable | disable
retries retries
17-8 Security Configuration
(Optional) Displays one or all RADIUS accounting server configurations.
(Optional) Displays counters for a RADIUS accounting server.
(Optional) Displays the maximum number of attempts to contact the
RADIUS accounting server before timing out.
(Optional) Displays the maximum amount of time before timing out.
Disabled
IP Address Acct-Port Retries Timeout Status
---------- --------- ------- ------- ------
172.16.2.10 1856
Enables or disables the RADIUS accounting client.
Sets the maximum number of attempts to contact a specified RADIUS
accounting server before timing out. Valid retry values are 0 ‐ 10.
3 20 Disabled