Set Maclock Static; Clear Maclock Static - Enterasys D-Series Cli Reference Manual

Example
This example shows how to remove a MAC from the list of static MACs allowed to communicate
on port
D2(rw)->clear maclock 0e-03-ef-d8-44-55 ge.3.2

set maclock static

Use this command to set the maximum number of static MAC addresses allowed per port. Static
MACs are administratively defined.
Syntax
set maclock static port-string value
Parameters
port‐string
value
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set the maximum number of allowable static MACs to 2 on
D2(rw)->set maclock static ge.3.1 2

clear maclock static

Use this command to reset the number of static MAC addresses allowed per port to the default
value of 20.
Syntax
clear maclock static port-string
Parameters
port‐string
Defaults
None.
.3.2:
ge
Specifies the port on which to set the maximum number of static MACs
allowed. For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 6‐1.
Specifies the maximum number of static MAC addresses allowed per
port. Valid values are 0 to 20.
Specifies the port on which to reset number of static MAC addresses
allowed. For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 6‐1.
set maclock static
Enterasys D-Series CLI Reference 17-57
.3.1:
ge