Show System Hardware; Show System Utilization - Enterasys D-Series Cli Reference Manual

show system hardware

show system hardware
Use this command to display the system's hardware configuration.
Syntax
show system hardware
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the system's hardware configuration. Please note that the
information you see displayed may differ from this example.
D2(su)->show system hardware

show system utilization

Use this command to display detailed information about the processor running on the switch, or
the overall memory usage of the Flash and SDRAM storage devices on the unit, or the processes
running on the switch. Only the memory usage in the master unit of a stack is shown.
Syntax
show system utilization {cpu | storage | process}
Parameters
cpu
storage
process
Defaults
None.
2-14 Basic Configuration
SLOT 1 HARDWARE INFORMATION
---------------------------
Model:
Serial Number:
Vendor ID:
Base MAC Address:
Hardware Version:
FirmWare Version:
Boot Code Version:
Display information about the processor running on the switch.
Display information about the overall memory usage on the switch.
Display information about the processes running on the switch.
D2G124-12
777777777777
0xbc00
00:11:88:B1:76:C0
BCM56514 REV 1
01.00.00.0052
01.00.42