Configuring Snmp Mib Views; Purpose; Commands; Show Snmp View - Enterasys D-Series Cli Reference Manual

Example
This example shows how to clear SNMP version 3 access for the "mis‐group" via the
authentication protocol:
D2(su)->clear snmp access mis-group security-model usm authentication

Configuring SNMP MIB Views

Purpose

To review and configure SNMP MIB views. SNMP views map SNMP objects to access rights.

Commands

For information about...

show snmp view

show snmp context
set snmp view
clear snmp view
show snmp view
Use this command to display the MIB configuration for SNMPv3 view‐based access (VACM).
Syntax
show snmp view [viewname] [subtree oid-or-mibobject] [volatile | nonvolatile |
read-only]
Parameters
viewname
subtree oid‐or‐mibobject
volatile | nonvolatile |
read‐only
Defaults
If no parameters are specified, all SNMP MIB view configuration information will be displayed.
Mode
Switch command, read‐only.
(Optional) Displays information for a specific MIB view.
(Optional) Displays information for a specific MIB subtree when
viewname is specified.
(Optional) Displays entries for a specific storage type.
Configuring SNMP MIB Views
Refer to page...
7-19
7-20
7-21
7-22
Enterasys D-Series CLI Reference 7-19