Clear Snmp Notify - Enterasys D-Series Cli Reference Manual

clear snmp notify

command's tag parameter can be used to bind each entry to a target address using the set snmp
targetaddr command ("set snmp targetaddr" on page 7‐26).
Syntax
set snmp notify notify tag tag [trap | inform] [volatile | nonvolatile]
Parameters
notify
tag tag
trap | inform
volatile |
nonvolatile
Defaults
If not specified, message type will be set to trap.
If not specified, storage type will be set to nonvolatile.
Mode
Switch command, read‐write.
Example
This example shows how to set an SNMP notify configuration with a notify name of "hello" and a
notify tag of "world". Notifications will be sent as trap messages and storage type will
automatically default to permanent:
D2(su)->set snmp notify hello tag world trap
clear snmp notify
Use this command to clear an SNMP notify configuration.
Syntax
clear snmp notify notify
Parameters
notify
Defaults
None.
Mode
Switch command, read‐write.
7-32 SNMP Configuration
Specifies an SNMP notify name.
Specifies an SNMP notify tag. This binds the notify name to the SNMP
target address table.
(Optional) Specifies SNMPv1 or v2 Trap messages (default) or SNMP v3
InformRequest messages.
(Optional) Specifies temporary (default), or permanent storage for SNMP
entries.
Specifies an SNMP notify name to clear.