Set Igmpsnooping Maxresponse; Set Igmpsnooping Mcrtrexpiretime - Enterasys D-Series Cli Reference Manual

Example
This example shows how to set the IGMP group membership interval to 250 seconds:
D2(su)->set igmpsnooping groupmembershipinterval 250

set igmpsnooping maxresponse

Use this command to configure the IGMP query maximum response time for the system.
Syntax
set igmpsnooping maxresponse time
Parameters
time
Defaults
None.
Mode
Switch command, read‐write.
Usage
This value must be less than the IGMP maximum response time described in "set igmpsnooping
groupmembershipinterval" on page 13‐4.
Example
This example shows how to set the IGMP maximum response time to 100 seconds:
D2(su)->set igmpsnooping maxresponse 100

set igmpsnooping mcrtrexpiretime

Use this command to configure the IGMP multicast router expiration time for the system.
Syntax
set igmpsnooping mcrtrexpire time
Parameters
time
Specifies the IGMP maximum query response time. Valid values are 100 ‐
255 seconds. The default value is 100 seconds.
This value works together with the set igmpsnooping
groupmembershipinterval command to remove ports from an IGMP group
and must be lesser than the group membership interval value.
Specifies the IGMP multicast router expiration time. Valid values are 0 ‐
3600 seconds. A value of 0 will configure the system with an infinite
expiration time. The default value is 0.
set igmpsnooping maxresponse
Enterasys D-Series CLI Reference 13-5