Set Rmon History; Clear Rmon History - Enterasys D-Series Cli Reference Manual

Sample
Drop Events
Octets
Packets
Broadcast Pkts
Multicast Pkts
CRC Align Errors

set rmon history

Use this command to configure an RMON history entry.
Syntax
set rmon history index [port-string] [buckets buckets] [interval interval] [owner
owner]
Parameters
index‐list
port‐string
buckets buckets
interval interval
owner owner
Defaults
If buckets is not specified, the maximum number of entries maintained will be 50.
If not specified, interval will be set to 30 seconds.
If owner is not specified, monitor will be applied.
Mode
Switch command, read‐write.
Example
This example shows how configure RMON history entry 1 on port fe.2.1 to sample every 20
seconds:
D2(rw)->set rmon history 1

clear rmon history

Use this command to delete one or more RMON history entries or reset one or more entries to
default values. For specific values, refer to "set rmon history" on page 15‐7.
Syntax
clear rmon history {index-list | to-defaults}
2779 Interval Start: 1 days 0 hours 2 minutes 22 seconds
= 0
= 0
= 0
= 0
= 0
= 0
Specifies an index number for this entry.
(Optional) Assigns this entry to a specific port.
(Optional) Specifies the maximum number of entries to maintain.
(Optional) Specifies the sampling interval in seconds.
(Optional) Specifies an owner for this entry.
fe
Undersize Pkts = 0
Oversize Pkts = 0
Fragments = 0
Jabbers = 0
Collisions = 0
Utilization(%) = 0
.2.1 interval 20
set rmon history
Enterasys D-Series CLI Reference 15-7