Enterasys D-Series Cli Reference Manual page 474

show dot1x
If port‐string is not specified, information for all ports will be displayed.
Mode
Switch command, read‐only.
Examples
This example shows how to display 802.1X status:
D2(su)->show dot1x
DOT1X is disabled.
This example shows how to display authentication diagnostics information for fe.1.1:
D2(su)->show dot1x auth-diag
Port : 1
Enter Connecting:
EAP Logoffs While Connecting:
Enter Authenticating:
Success While Authenticating
Timeouts While Authenticating:
Fails While Authenticating:
ReAuths While Authenticating:
EAP Starts While Authenticating:
EAP logoff While Authenticating:
Backend Responses:
Backend Access Challenges:
Backend Others Requests To Supp:
Backend NonNak Responses From:
Backend Auth Successes:
Backend Auth Fails:
This example shows how to display authentication statistics for fe.1.1:
D2(su)->show dot1x auth-stats
Port: 1
EAPOL Frames Rx:
EAPOL Frames Tx:
EAPOL Start Frames Rx:
EAPOL Logoff Frames Rx:
EAPOL RespId Frames Rx:
EAPOL Resp Frames Rx:
EAPOL Req Frames Tx:
EAP Length Error Frames Rx:
Last EAPOL Frame Version:
Last EAPOL Frame Source:
This example shows how to display the status of port reauthentication control for fe.1.1 through
fe.1.6:
D2(su)->show dot1x port reauth
Port 1: Port reauthenticate:
Port 2: Port reauthenticate:
Port 3: Port reauthenticate:
Port 4: Port reauthenticate:
Port 5: Port reauthenticate:
Port 6: Port reauthenticate:
17-12 Security Configuration
fe
Auth-Diag
Auth-Stats
.1.1
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
fe
.1.1
0
0
0
0
0
0
0
0
0
00:00:00:00:00:00
fe
.1.1-6
FALSE
FALSE
FALSE
FALSE
FALSE
FALSE