2.
Load your previous version of code on the device, as described in "Downloading a Firmware
Image" (page 2‐28).
3.
Set this older version of code to be the boot code, as described in "Reviewing and Selecting a
Boot Firmware Image" (page 2‐31).
4.
Reload the saved configuration onto the device as described in"configure" (page 2‐39).
Reviewing and Selecting a Boot Firmware Image
Purpose
To display and set the image file the switch loads at startup. The D2 switch allows you to
download and store a backup image, which can be selected as the startup image by using the
commands described in this section.
Commands
For information about...
show boot system
set boot system
show boot system
Use this command to display the firmware image the switch loads at startup.
Syntax
show boot system
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the switch's boot firmware image:
D2(su)->show boot system
Current system image to boot: bootfile
Reviewing and Selecting a Boot Firmware Image
Refer to page...
2-31
2-32
Enterasys D-Series CLI Reference 2-31