Clear Snmp User - Enterasys D-Series Cli Reference Manual

clear snmp user

Parameters
user
remote remoteid
authentication md5
| sha
authpassword
privacy privpassword (Optional) Applies encryption and specifies an encryption password.
volatile |
nonvolatile
Defaults
If remote is not specified, the user will be registered for the local SNMP engine.
If authentication is not specified, no authentication will be applied.
If privacy is not specified, no encryption will be applied.
If storage type is not specified, nonvolatile will be applied.
Mode
Switch command, read‐write.
Example
This example shows how to create a new SNMP user named "netops". By default, this user will be
registered on the local SNMP engine without authentication
user will be stored in permanent (nonvolatile) memory:
D2(su)->set snmp user netops
clear snmp user
Use this command to remove a user from the SNMPv3 security‐model list.
Syntax
clear snmp user user [remote remote]
Parameters
user
remote remote
Defaults
If remote is not specified, the user will be removed from the local SNMP engine.
Mode
Switch command, read‐write.
7-10 SNMP Configuration
Specifies a name for the SNMPv3 user.
(Optional) Registers the user on a specific remote SNMP engine.
(Optional) Specifies the authentication type required for this user as MD5
or SHA.
(Optional) Specifies a password for this user when authentication is
required. Minimum of 8 characters.
Minimum of 8 characters.
(Optional) Specifies a storage type for this user entry.
Specifies an SNMPv3 user to remove.
(Optional) Removes the user from a specific remote SNMP engine.
and encryption. Entries related to this