Set Rmon Channel - Enterasys D-Series Cli Reference Manual

set rmon channel

Example
This example shows how to display RMON channel information for fe.2.12:
D2(rw)->show rmon channel
fe
Port
----------------------------------------------------------
Control
OnEventIndex
EventIndex
Matches
Description
Owner
set rmon channel
Use this command to configure an RMON channel entry.
Syntax
set rmon channel index port-string [accept {matched | failed}] [control {on | off}]
[description description] [owner owner]
Parameters
index
port‐string
accept matched |
failed
control on | off
description
description
owner owner
Defaults
If an action is not specified, packets will be accepted on filter matches.
If not specified, control will be set to off.
If a description is not specified, none will be applied.
If owner is not specified, it will be set to monitor.
Mode
Switch command, read‐write.
15-18 RMON Configuration
.2.12 Channel index= 628
off
0
0
4498
Thu Dec 16 12:57:32 EST 2004
NetSight smith
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 2. Maximum value is 65535.
Specifies the port on which traffic will be monitored.
(Optional) Specifies the action of the filters on this channel as:
• matched ‐ Packets will be accepted on filter matches
• failed ‐ Packets will be accepted if they fail a match
(Optional) Enables or disables control of the flow of data through the
channel.
(Optional) Specifies a description for this channel.
(Optional) Specifies the name of the entity that configured this entry.
fe
.2.12
EntryStatus= valid
AcceptType
OffEventIndex
Status
matched
0
ready