Clear Spantree Spanguardtimeout; Show Spantree Spanguardlock - Enterasys D-Series Cli Reference Manual

clear spantree spanguardtimeout

clear spantree spanguardtimeout
Use this command to reset the Spanning Tree SpanGuard timeout to the default value of 300
seconds.
Syntax
clear spantree spanguardtimeout
Parameters
None.
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to reset the SpanGuard timeout to 300 seconds:
D2(rw)->clear spantree spanguardtimeout

show spantree spanguardlock

Use this command to display the SpanGuard lock status of one or more ports.
Syntax
show spantree spanguardlock [port-string]
Parameters
port‐string
Defaults
If no port string is specified, the SpanGuard lock status for all ports is displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display the SpanGuard lock status for
D2(su)->show spantree spanguardlock ge.1.1
Port ge.1.1 is Unlocked
8-28 Spanning Tree Configuration
(Optional) Specifies the port(s) for which to show SpanGuard lock status.
For a detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 6‐1.
.1.1:
ge