Show Pwa Session - Enterasys D-Series Cli Reference Manual

show pwa session

Parameters
enable | disable
port‐string
Defaults
If port‐string is not specified, PWA will enabled on all ports.
Mode
Switch command, read‐write.
Example
This example shows how to enable PWA on ports 1‐22:
D2(su)->set pwa portcontrol enable ge.1.1-22
show pwa session
Use this command to display information about current PWA sessions.
Syntax
show pwa session [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, session information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display PWA session information:
D2(su)->show pwa session
Port
-------- ----------------- --------------- ------------- ------------ ---------
ge.2.19
ge.2.19
ge.2.19
17-72 Security Configuration
Enables or disables PWA on specified ports.
(Optional) Sets the control mode on specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 6‐1.
(Optional) Displays PWA session information for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 6‐1.
MAC IP
00-c0-4f-20-05-4b 172.50.15.121
00-c0-4f-24-51-70 172.50.15.120
00-00-f8-78-9c-a7 172.50.15.61
User Duration
pwachap10 0,14:46:55
pwachap1 0,15:43:30
pwachap11 0,14:47:58
Status
active
active
active