Clear / Set Spantree Spanguardlock; Show Spantree Spanguardtrapenable - Enterasys D-Series Cli Reference Manual

clear / set spantree spanguardlock

Use either of these commands to unlock one or more ports locked by the Spanning Tree
SpanGuard function. When SpanGuard is enabled, it locks ports that receive BPDUs when those
ports have been defined as edge (user) ports (as described in "set spantree adminedge" on
page 8‐39).
Syntax
clear spantree spanguardlock port-string
set spantree spanguardlock port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to unlock port
D2(rw)->clear spantree spanguardlock ge.1.16

show spantree spanguardtrapenable

Use this command to display the state of the Spanning Tree SpanGuard trap function.
Syntax
show spantree spanguardtrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the state of the SpanGuard trap function:
D2(ro)->show spantree spanguardtrapenable
Spanguard SNMP traps are enabled
Specifies port(s) to unlock. For a detailed description of possible port‐string
values, refer to "Port String Syntax Used in the CLI" on page 6‐1.
.1.16:
ge
clear / set spantree spanguardlock
Enterasys D-Series CLI Reference 8-29