set port duplex
Example
This example shows how to display the default duplex setting for Ethernet port 14 in slot 3:
D2(su)->show port duplex ge.3.14
default duplex mode is full on port ge.3.14.
set port duplex
Use this command to set the default duplex type for one or more ports. This command will only
take effect on ports that have auto‐negotiation disabled.
Syntax
set port duplex port-string {full | half}
Parameters
port‐string
full | half
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to set fe.1.17 to full duplex:
D2(su)->set port duplex
6-12 Port Configuration
Specifies the port(s) for which duplex type will be set. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 6‐1.
Sets the port(s) to full‐duplex or half‐duplex operation.
fe
.1.17 full