Enterasys D-Series Cli Reference Manual page 329

Parameters
The following parameters apply to deleting an admin rule.
admin‐profile
vlantag data
mask mask
The following parameters apply to deleting a classification rule.
profile‐index
all‐pid‐entries
ether
icmptype
ipproto
ipdestsocket
ipsourcesocket
iptos
macdest
macsource
tcpdestport
tcpsourceport
udpdestport
udpsourceport
Defaults
When applicable, data and mask must be specified for individual rules to be cleared.
Mode
Switch command, read‐write.
Examples
This example shows how to delete Ethernet II Type 1526 classification rule entries associated with
policy profile 1 from all ports
D2(su)->clear policy rule 1 ether 1526
This example shows how to remove a rule from policy profile 5 that will forward UDP frames
from source port 45:
D2(su)->clear policy rule 5 udpportsource 45 forward
Specifies that the rule to be deleted is an admin rule for policy ID 0.
Deletes the rule based on VLAN tag specified by data. Value of data can
range from 1 to 4094 or 0xFFF.
(Optional) Specifies the number of significant bits to match, dependent
on the data value entered. Value of mask can range from 1 to 12.
Refer to Table 11‐30 for valid values for each classification type and data
value.
Specifies a policy profile for which to delete classification rules. Valid
profile‐index values are 1 ‐ 255.
Deletes all entries associated with the specified policy profile.
Deletes associated Ethernet II classification rule.
Deletes associated ICMP classification rule.
Deletes associated IP protocol classification rule.
Deletes associated IP destination classification rule.
Deletes associated IP source classification rule.
Deletes associated IP Type of Service classification rule.
Deletes associated MAC destination address classification rule.
Deletes associated MAC source address classification rule.
Deletes associated TCP destination port classification rule.
Deletes associated TCP source port classification rule.
Deletes associated UDP destination port classification rule.
Deletes associated UDP source port classification rule.
clear policy rule
Enterasys D-Series CLI Reference 11-13