Commands; Show Policy Profile - Enterasys D-Series Cli Reference Manual

show policy profile

Commands

For information about...
show policy profile
set policy profile
clear policy profile
show policy profile
Use this command to display policy profile information.
Syntax
show policy profile {all | profile-index [consecutive-pids] [-verbose]}
Parameters
all | profile‐index
consecutive‐pids
‐verbose
Defaults
If optional parameters are not specified, summary information will be displayed for the specified
index or all indices.
Mode
Switch command, read‐only.
Example
This example shows how to display policy information for profile 11:
D2(su)->show policy profile 11
Profile Index
Profile Name
Row Status
Port VID Status
Port VID Override
CoS
CoS Status
Egress Vlans
Forbidden Vlans
Untagged Vlans
Rule Precedence
11-2 Policy Classification Configuration
Note: B3, C3, and G3 devices support profile-based CoS traffic rate limiting only. Policy rules
specifying CoS will only rate limit on D2, C2 and B2 devices, including when they are configured on
mixed stacks containing B3 and C3 devices.
Displays policy information for all profile indexes or a specific profile index.
(Optional) Displays information for specified consecutive profile indexes.
(Optional) Displays detailed information.
: 11
: MacAuth1
: active
: Enable
: 11
: 0
: Disable
: none
: none
: none
: 1-31
:MACSource(1),MACDest(2),Unknown(3),
:Unknown(4),Unknown(5),Unknown(6),
:Unknown(7),Unknown(8),Unknown(9),
:Unknown(10),Unknown(11),IPSource(12),
Refer to page...
11-2
11-3
11-4