Clear Logging Server; Show Logging Default - Enterasys D-Series Cli Reference Manual

clear logging server

Example
This command shows how to enable a Syslog server configuration for index 1, IP address
134.141.89.113, facility local4, severity level 3 on port 514:
D2(su)->set logging server 1 ip-addr 134.141.89.113 facility local4 severity 3
port 514 state enable
clear logging server
Use this command to remove a server from the Syslog server table.
Syntax
clear logging server index
Parameters
index
Defaults
None.
Mode
Switch command, read‐write.
Example
This command shows how to remove the Syslog server with index 1 from the server table:
D2(su)->clear logging server 1

show logging default

Use this command to display the Syslog server default values.
Syntax
show logging default
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
14-4 Logging and Network Management
Specifies the server table index number for the server to be removed.
Valid values are 1 ‐ 8.