Assigning Port Vlan Ids (Pvids) And Ingress Filtering; Purpose; Commands; Show Port Vlan - Enterasys D-Series Cli Reference Manual

Assigning Port VLAN IDs (PVIDs) and Ingress Filtering

Assigning Port VLAN IDs (PVIDs) and Ingress Filtering

Purpose

To assign default VLAN IDs to untagged frames on one or more ports, to configure VLAN ingress
filtering and constraints, and to set the frame discard mode.

Commands

For information about...

show port vlan

set port vlan
clear port vlan
show port ingress filter
set port ingress filter
show port discard
set port discard
show port vlan
Use this command to display port VLAN identifier (PVID) information. PVID determines the
VLAN to which all untagged frames received on one or more ports will be classified.
Syntax
show port vlan [port-string]
Parameters
port‐string
Defaults
If port ‐string is not specified, port VLAN information for all ports will be displayed.
Mode
Switch command, read‐only.
Example
This example shows how to display PVIDs assigned to fe.2.1 through 6. In this case, untagged
frames received on these ports will be classified to VLAN 1:
D2(su)->show port vlan
fe
.2.1 is set to 1
fe
.2.2 is set to 1
fe
.2.3 is set to 1
fe
.2.4 is set to 1
9-8 802.1Q VLAN Configuration
(Optional) Displays PVID information for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax Used
in the CLI" on page 6‐1.
fe
.2.1-6
Refer to page...
9-8
9-9
9-9
9-10
9-11
9-11
9-12