3Com Router 3000 Ethernet Family
Configuration Guide
PSTN, so that the user can establish the connection between PC and the remote router
by dial-up on the PC. After the dial-up is successful, the user can set the working
parameters of the remote routers through entering the configuration commands on the
terminal. The configuration environment is displayed in Figure 11-1.
Asynchronous
Serial interface
Figure 11-1 Establish remote configuration environment through AUX interface
11.3.2 Terminal Service Characteristics of the Remote Config on AUX Port
System terminal service characteristics of the remote configuration are listed in the
following table.
Table 11-2 Terminal service characteristics of the remote configuration
Service
Echo mode
Terminal type
Baud rate
Data bit
Parity check
Stop bit
Flow control
The terminal program running on PC should accord with parameters set in the above
table. The baud rate, data bit, parity check and flow control should be consistent with
the corresponding configurations on the AUX port of the router.
Router
Modem
Without local echo
VT100
Consistent with the interface configuration, 9600 bps by default
Consistent with the interface configuration, 8 bits by default
Consistent with the interface configuration, none by default
Consistent with the interface configuration, 1 bit by default
Consistent with the interface configuration, none by default
3Com Corporation
11-2
Terminal
Modem
PSTN
Characteristics
Chapter 11 Terminal Services