3Com 3C13636 Configuration Manual page 197

3Com Router 3000 Ethernet Family
Configuration Guide
NMS NMS
129.1.1.111/24 129.1.1.111/24
Figure 10-1 Network diagram for RMON
III. Configuration procedure
# Configure SNMP, using the same read/write community and version configured on .
[3Com] snmp-agent
[3Com] snmp-agent community read public
[3Com] snmp-agent community write private
[3Com] snmp-agent sys-info version v1
[3Com] snmp-agent trap enable
[3Com] snmp-agent target-host trap address udp-domain 129.1.1.111 params
securityname 3Com
# Configure a RMON alarm entry.
[3Com] rmon event 1 description rising trap router1 owner 3Com-rmon
[3Com] rmon event 1 description falling trap router1 owner 3Com-rmon
[3Com] rmon alarm 1 1.3.6.1.2.1.16.1.1.1.4.1 5 delta rising_threshold 100 1
falling_threshold 50 2
# Assign an IP address to interface Ethernet 0/0/0.
[3Com] interface ethernet 0/0/0
[3Com-Ethernet0/0/0] ip address 129.1.1.100 255.255.255.0
# Set a RMON statistics entry for the Ethernet interface.
[3Com-Ethernet0/0/0] rmon statistics 1 owner 3Com-rmon
[3Com-Ethernet0/0/0] quit
# Display information about RMON alarm entry 1 and statistics about the Ethernet
interface.
<3Com> display rmon alarm 1
<3Com> display rmon statistics ethernet 0/0/0
When the alarm event is triggered, you can find its record in the fault management
module of .
Ethernet Ethernet
e0/0/0: e0/0/0:
129.1.1.100/24 129.1.1.100/24
Router A Router A
3Com Corporation
10-6
Chapter 10 RMON Configuration
Console port Console port
Console terminal Console terminal