3Com 3C13636 Configuration Manual page 132

3Com Router 3000 Ethernet Family
Configuration Guide
II. Displaying the current and initial configurations of the router
When the router is powdered on, it reads out a configuration file in the default storage
path to execute the initialization. So the configuration file in the default storage path is
called startup configuration. If there is no configuration file in the default storage path,
the router will use default parameters to execute the initialization. Compared with the
startup configuration, the valid configuration of the router during running is called
current configuration.
Perform the following configuration in any view.
Table 5-22 Display the router configuration
Display the configuration file loaded at
this startup
Display the configuration file used at this
startup and the one used for next startup
Display the configurations for current
view
Display the running configurations of the
router
Note:
The format used for displaying the configuration file is the same as that for saving the
file.
III. Modifying and saving the current configuration
The user can modify the current configuration of the router through the command line
interface. In order to make the current configuration as the startup configuration of the
router at the next power-on, use the save command to save the current configuration
into the default storage device.
Perform the following configuration in any view.
Table 5-23 Save the current configuration
Save the current configuration
Operation
Operation
3Com Corporation
5-18
Chapter 5 File Management
Command
display saved-configuration
[ by-linenum ]
display startup
display this [ by-linenum ]
display current-configuration
[ controller | interface interface-type
[ interface-number ] | configuration [ isp
| luser | radius-template | system |
user-interface| ] ] [ | [ begin | include |
exclude ] string ] [ by-linenum ]
Command
save [ file-name ] [ safely ]