3Com 3C13636 Configuration Manual page 302

3Com Router 3000 Ethernet Family
Configuration Guide
Table 1-10 Assign IP addresses picked from a global address pool
Configure a global IP address pool
Remove the global IP address pool
Assign the global address pool to an interface
for address assignment to PPP users
Disable the interface to assign IP addresses to
PPP users
By default, the interface does not assign IP address to the remote end. If the
pool-number argument is not specified in the remote address pool command, the
default global address pool, pool 0, is used.
Note:
The above two methods are used where PPP authentication is not required, and the
third method to be described is used where PPP authentication is required.
3) Method 3: Assign an IP address picked from a domain address pool
In this approach, you need to do the following:
Create a domain address pool in domain view.
Assign the domain address pool to the interface by executing the remote
address pool command in interface view. If this command is not configured, the
system looks up the address pools of the domain in turn to pick an address for
the peer during the authentication negotiation with the peer.
Table 1-11 Use domain address pools for address assignment
Configure a domain IP address pool
Remove the domain IP address pool
Assign the domain address pool to an
interface for address assignment to PPP
users
Disable the interface to assign IP
addresses to PPP users
Operation
Operation
3Com Corporation
1-10
Chapter 1 PPP and MP Configuration
Command
ip pool
low-ip-address
[ high-ip-address ]
undo ip pool pool-number
remote address
[ pool-number ]
undo remote address
Command
ip pool pool-number low-ip-address
[ high-ip-address ]
undo ip pool pool-number
remote address pool [ pool-number ]
undo remote address
pool-number
pool