3Com 3C13636 Configuration Manual page 96

3Com Router 3000 Ethernet Family
Configuration Guide
When performing an FTP test, you must specify a source port.
Perform the following configurations in HWPing test group view.
Table 4-9 Configure a source port
Configure a source port.
Delete the configuration of the source
port.
By default, source port is not specified.
6) Configure test type
You may test various connections by using the HWPing function, but only a type at
each time. In other words, a test group can serve only the HWPing test on the
connection of one type.
The test types provided by HWPing include icmp, udppublic, udpprivate, tcppublic,
tcpprivate, dlsw, dhcp, snmpquery, ftp, and http.
Perform the following configuration in HWPing test group view.
Table 4-10 Configure a test type
Configure a test type.
By default, test type is set to ICMP.
7) Configure the number of messages sent for a test
Suppose that the number of the messages sent for a test is greater than 1. After
sending the first test message, the system sends the second one upon the receipt of
the acknowledgement to the first one or upon the expiration of the test timer in the case
that it has not received any acknowledgement, until it sends all the test messages as
configured. The parameter discussed in this subsection is equal to the argument "-n" in
a ping command.
Perform the following configurations in HWPing test group view.
Table 4-11 Configure the number of messages sent for a test
Configure the number of messages sent
for a test.
Operation
Operation
Operation
3Com Corporation
4-6
Chapter 4 HWPing Configurations
Command
source-port port-number
undo source-port
Command
test-type { icmp
udpprivate | tcppublic | tcpprivate |
dlsw | dhcp | snmpquery | ftp | http }
Command
count times
| udppublic |