3Com 3C13636 Configuration Manual page 95

3Com Router 3000 Ethernet Family
Configuration Guide
Table 4-6 Configure a destination port
Configure a destination port.
Delete the destination port.
By default, no destination port number is configured.
3) Configuring a source interface
When carrying out a DHCP test, you may specify a source interface, which must be an
FE or GE interface, for sending a DHCP request. If a source interface has been
specified for the DHCP test, the system will directly use it to send the DHCP request
rather than determining an output interface via routing. In addition, the source IP
address carried in the DHCP request will be the IP address of the specified interface.
Perform the following configurations in HWPing test group view.
Table 4-7 Bind a source interface
Bind a source interface.
Remove the source interface.
By default, source interface is not configured.
4) Configuring source address
When carrying out a DHCP test, you may specify a source IP address for sending a
DHCP request. DHCP Server will use this IP address as the destination address in the
returned response packet.
Perform the following configurations in HWPing test group view.
Table 4-8 Configure a source address
Configure a source address.
Delete the source address.
By default, source IP address is not specified.
5) Configure a source port
When doing a DHCP test, you may specify a source port for sending a DHCP request.
DHCP Server will use this port number as the destination port number in the returned
response packet.
Operation
Operation
Operation
3Com Corporation
4-5
Chapter 4 HWPing Configurations
Command
destination-port port-number
undo destination-port
Command
source-interface
interface-number
undo source-interface
Command
source-ip ipaddress
undo source-ip
interface-type