3Com 3C13636 Configuration Manual page 123

3Com Router 3000 Ethernet Family
Configuration Guide
II. Configuring idle-timeout disconnection of FTP
To prevent illegal accesses, the connection with an FTP client will be disconnected if no
service request from the client has been received for a certain period.
Perform the following configuration in the system view.
Table 5-11 Configure the timeout of the FTP server
Configure the timeout time of the FTP
server.
Restore the timeout time of the FTP
server to the default value.
The default idle-timeout time is 30 minutes.
III. Specifying a source interface/IP address for the FTP server
Perform the following configuration in system view.
Table 5-12 Specify a source interface or source IP address for the FTP server
Specify a source interface for the FTP
server
Delete the source interface specified for
the FTP server
Specify a source IP address for the
packets sent by the FTP server
Delete the source IP address specified
for the FTP server
By default, the source IP address in each packet sent by the FTP server is the IP
address of the interface where the packet is sent out.
Note:
You may specify a source IP address for the packets sent by the FTP server with the
ftp-server source-interface command or with the ftp-server source-ip command. If
both commands are configured, the one configured later overrides the former.
5.3.5 Displaying and Debugging
Operation
Operation
3Com Corporation
5-9
Chapter 5 File Management
Command
ftp timeout minutes
undo ftp timeout
Command
ftp-server
interface-type interface-number
undo ftp-server source-interface
ftp-server source-ip ip-address
undo ftp-server source-ip
source-interface