Table of Contents
Advertisement
Procedure
1. Install one or more tape drives.
For installation and cabling instructions, see the document that came with the tape drive or the library
user guide.
2. Install one or more power supplies.
For installation and cabling instructions, see the document that came with the power supply or the
library user guide.
Verifying the installation and configuration of a newly added module
Procedure
1. Verify that the library powers on and initializes correctly, and that the status is Ready.
2. From the RMI, verify that the new module is visible.
3. Review the library configuration settings associated with the additional storage slots, mailslots, and
tape drives, and update the configuration if necessary.
4. Optional: Label and load cartridges into the storage slots.
a. From the OCP, navigate to the Open Magazine/Mailslot > Open Magazine screen.
The library lights an LED for each magazine in the library.
b. Press the magazine release button for the magazine to be opened.
c. Pull the magazine straight out of the library, supporting the bottom with your hand.
d. Insert one or more labeled cartridges into the storage slots in the magazine.
The lowest row of storage slots in the library is inaccessible to the robot, so do not load cartridges
in those slots. If the library detects cartridges in the lowest row it will mark them as inaccessible and
not use them for backup operations.
5. Verify that the library has the current firmware version.
2
1
Verifying the installation and configuration of a newly added module
127
Advertisement
Table of Contents
