Figure 11: Assign Destination Code To Route Numbers - Nortel BCM200 Configuration Manual

AT&T IP Flexible Reach Service
Nortel BCM200/400 (Release 4.0.2.03a) H.323 Configuration Guide
Configuration Telephony Dialing Plan Routing
Under
Under the "Destination Codes" tab we need to associate the Route to the desired
access code. Configure this to access code "9" or to whatever code you want to
access for outside (IP off-net) call that will be presented to the AT&T service for
routing. In this case, when "9" is dialed we wish to push the dialed string to the
IP trunk for routing.
Note: When completing the Technical Questionnaire Section 6.0 Dial Plan
Information and the private dial plan is selected (YES), then please refer to
Appendix 'A': Configuring Destination Code with Wildcard
.

Figure 11: Assign Destination Code to Route Numbers

© 2008 AT&T Knowledge Ventures. All rights reserved. AT&T and the AT&T logo are trademarks of AT&T
Knowledge Ventures. Subsidiaries and affiliates of AT&T Inc. provide products and services under the AT&T brand.
Issue 1.9 Page 18 of 36