Cmos Battery (Cr2032) Replacement - Lenovo ThinkSystem SD550 V3 User Manual

Figure 44. Installation of the internal CFF RAID adapter to the bracket
Step 2. Reinstall the internal adapter bracket to the node (see
129) and reconnect the all the required power and signal cables and drive cables to the CFF RAID
adapter (see "2.5-inch drive backplane cable routing" on page
Step 3. (Optional) If necessary, make sure to connect the CFF RAID adapter to the flash power module (see
"2.5-inch drive backplane cable routing" on page
After this task is completed
1. Make sure that all the required cables are routed and connected correctly; then, reinstall the top cover
(see "Install the top cover" on page
2. Reinstall the node into the chassis (see
3. Make sure that the required power supply units are installed and power cords are connected; then,
power on the node (see
53.)
4. Proceed to complete the parts replacement (see

CMOS battery (CR2032) replacement

Follow instructions in this section to remove or install the CMOS battery (CR2032).
Remove the CMOS battery (CR2032)
Follow instructions in this section to remove the CMOS battery (CR2032).
About this task
To avoid potential danger, make sure to read and follow the safety information.
S004
205).
"Install a node to the chassis" on page
"Install a hot-swap power supply" on page 63
"Install an internal adapter bracket" on page
215).
215).
and
"Complete the parts replacement" on page
.
Chapter 5 Hardware replacement procedures
78).
"Power on the node" on page
208).
91