Roland VersaUV LEF2-200 Service Notes page 87

Board Replacement
13-5.
IP address setting
* Start the machine with the service mode and set in the user menu .
13-6.
Firmware version confirmation of network controller
" Refer to Firmware version confirmation of network controller
13-7.
Head rank setting
* Set in [PRINT MENU] > [HEAD RANK] .
13-8.
Serial number input
* Set in [SUB MENU] > [SERIAL NO .] .
13-9.
Ink type setting
* Set in [SUB MENU] > [CHANGE INKTYPE] .
13-10.
Cap & wiper check
* Set in [IS MENU] > [IS CHECK] .
13-11.
Sensor check
* Set from [SERVICE MENU] > [SENSOR CHECK] .
13-12.
Limit position & cut down position initialization
" Refer to chapter 2 "Limit position & cut down position initialization" .
13-13.
Flushing position adjustment
" Refer to chapter 2 ""Flushing Position Adjustment" .
13-14.
Linear encoder setup
" Refer to Chapter 2 "Linear Encoder Setup" .
13-15.
Paper side sensor level adjustment
13-16.
Print head alignment
" Refer to Chapter 2 "Print Head Alignment" .
* Only horizontal adjustment is required .
Servo board replacement
Servo board connector layout
CN18
CN17
CN2
CN8
CN10 CN7
CN6
CN11
CN1
1-80
1
L EF 2-200