Roland VersaUV LEF2-200 Service Notes page 118

UV Lamp Replacement
2.
Perform [SERVICE MENU] > [MOTOR MENU] > [AXIS MOVE] > [HEIGHT] to set the Height to 103 mm .
C AUTION
Be sure that the table unit is in a position anterior to the head gap sensor plate . When the table unit hits the plate, the table
unit stops rising at 102 mm, not rising to 103 mm .
3.
Turn off the power switch, and open the front cover . Then, move the head carriage to the left by hand .
C AUTION
Move the head carriage to the position where the print head surface does not hit the table .
4.
Remove the UV lamp together with the plate .
5.
Attach the new UV lamp to the plate, and attach them to the machine .
1
1 . Table
1-111
1
L EF 2-200