Roland VersaUV LEF2-200 Service Notes page 169

Print Head Alignment
BIAS Adjustment
9.
Remove the panel cover .
10.
Loosen three screws that secure the print head in the order as shown below .
C AUTION
Loosen the screws that secure the print head approximately 1/2 turn . If the screws are too loose, it may affect the result of
this alignment .
Top view
2
1
3
11.
Insert the 1 .5 mm hexagonal wrench through the hole of the print-head carriage . Then, turn the adjustment screw to
make the lines of each color in the test pattern straight .
NOTE
The position of the printing moves 1 line by turning the screw approximately 3/4 turn .
2-28
2
L EF 2-200