Roland VersaUV LEF2-200 Service Notes page 194

Belt Position Adjustment
5.
Press the [ENTER] key to cancel aging .
SCAN
NOW AGING
6.
Loosen two fixing screws located at the left end of the belt eighth to quarter round .
C AUTION
If you loosen the screws too much, it will make it difficult to adjust the belt position . Be careful with the sharp edges around
the belt when loosening the screws . It may cause injury .
7.
Insert a wrench through the holes on the side frame prepared for the adjustment, and loosen the two screws to make a
gap of 3 mm between the tip of the screw and idle pulley holder .
NOTE
The gap between the screws and the idle pulley holder can be seen from both the front side and rear side of the machine .
1 . Idle pulley holder
8.
Press the [ENTER] key to restart aging .
AGING
SCAN
[ ]
3 mm
1
[ ]
2-53
2
L EF 2-200