Belt Position Adjustment
10.
Tighten one of the screws that have no contact with the idle pulley holder until the screw slightly touches the idle pulley
holder .
1
2
C AUTION
Do not overtighten the screws . Overtightening could move the idle pulley holder .
11.
Tighten two fixing screws .
C AUTION
Be cautious with the moving carriages and cableveyor during this procedure, and also with the sharp edges of the
mechanical parts around it .
12.
Confirm that the belt is not touching the pulley flanges excessively while the carriages are in the printing area . When the
belt is improperly positioned, adjust it again . When positioning is correct, press the [ENTER] key to cancel aging .
SCAN
NOW AGING
13.
(End of procedure)
[ ]
2-55
2
L EF 2-200