Roland VersaUV LEF2-200 Service Notes page 191

Belt Position Adjustment
4.
Remove the screws that secure the hinge, and then remove the front cover .
5.
Remove the screws as shown in the figure and remove the top cover .
Workflow
C AUTION
• This adjustment is to prevent the belt wear which is caused by the belt contacting the pulley flanges excessively . The belt
position needs to be checked after the belt tension adjustment and adjusted if necessary .
• When adjusting the drive pulley side, the pressure of engagement between the white gear of the drive pulley and the
scan motor gear is changed, possibly resulting in teeth breaking on the white gear or failure of the scan motor . After the
belt position adjustment, be sure to loosen the screws fixing the scan motor and re-tighten them again .
2-50
2
L EF 2-200