Roland VersaUV LEF2-200 Service Notes page 19

Print Head Replacement
17.
Attach the spring . Then, fully tighten the screws using a torque driver in the order shown in the figure .
1
18.
Connect the ribbon cables to the print heads .
C AUTION
Be careful not to connect a wrong ribbon cable .
19.
Attach the head board cover .
C AUTION
When attaching the head board cover, make sure to hook the tab to the carriage base .
20.
Attach the adapter damper .
21.
Attach the ink dampers to the adapter damper .
C AUTION
• Ink dampers may break if you grasp them too hard .
• Attach the ink dampers with the head board cover attached . If ink drips on the head board, the print head or the head
driving IC will break .
2
3
1-12
1
L EF 2-200