Roland VersaUV LEF2-200 Service Notes page 186

Belt Tension Adjustment
• Always use the UV protection sheet during this adjustment, or ink will harden and clog inside the ink line .
1.
Measure the tension of the belt at the position [A] shown in the figure using TENSION GAUGE (ST-001) . Press the upper
belt downward with the gauge to make slight contact with the rail guide . The tension is proper when the measured value
is 0 .98 kgf to 1 .18 kgf (9 .8 cN/m to 11 .8 cN/m) . When the tension is not proper, move on to the next step and adjust the
belt tension .
Top view
Front view
A
Upper belt
Hold down the belt
with tension gauge
Rail guide
2-45
2
L EF 2-200