Roland VersaUV LEF2-200 Service Notes page 21

Print Head Replacement
C AUTION
• Fix the damper plate with screws while pressing it lightly with your hand . Be careful not to press it down to the dampers .
Dampers could break .
• Tighten the screws at the bottom of the slotted holes
24.
Turn on the main power switch . Then, turn on the sub power switch while pressing the [] [] [] keys to enter the
service mode .
25.
Select [SERVICE MENU] > [MOTOR MENU] > [AXIS MOVE] > [HEIGHT], and set the value to [102 .0 mm] .
SERVICE MENU
MOTOR MENU
MOTOR MENU
AXIS MOVE
AXIS MOVE
HEIGHT
AXIS MOVE
Z:102.0mm
26.
Move the head carriage to the left by hand .
27.
Check that the gap between the head surface and the table top is around 1 mm . If the head height is not around 1 mm,
perform Chapter 2 "Print Head Height Adjustment" .
Approx. 1 mm
[ ][ ]
[ ]
[ ENTER ]
[ ENTER ]
1-14
1
L EF 2-200